2000 Chevrolet Blazer Q&A
2000 Chevrolet Blazer Question: fuel pump sending unit
You will need to drain as much fuel is possible into a suitable container, Raise the vehicle on a lift. remove the filler tube and breather hose from tank, remove mounting straps and carefully lower tank a foor or two in order to reach above the tank and disconnect the fuel lines and emissions hoses. after it is disconnected you can lower the tank and replace the unit. Revearse the procedure to install. - kwmk
I have been banging my head for the past few months - replaced the fuel pump/wire pig tail with AC Delco ( and new fuel filter ). Worked for a few weeks - then no pressure/juice to pump. Dropped ...
do the fuel pump sending unit cause the fuel gauge to not respond until you raise the rpm or start the vehicle to moving.
The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module ass...
we have changed all of the sensors, fuel pump, sending unit, converters cleaned out, checked wiring, cap rotor, plug wires, and it still runs bad. what could it be
i have a 95 s-10 blazer (4.3, 4x4, 4 dr auto w/ ac) and i am having a problem with the fuel pump relay.. i think! symptoms: intermitantly, the truck will not start, no fuel pump primer whine, no...