2000 Buick LeSabre Q&A

2000 Buick LeSabre Question: Fuel Pressure Regulator

Based on what I read on this site I need to buy a fuel pressure regulator to get rid of the occasional strong fuel smell coming through the vents and detectable outside the car near the hood. Do I need a seal kit with that from Delco or is that for something else? I assume this is a very straightforward diconnect and connect procedure, right? -
Answer 1
You need to install new O-ring seals from the dealer, they may not come with the regulator part. It's a fairly straightforward procedure to replace the regulator. -
Comment 1
They replaced the fuel pressure regulator. I still had the problem. Took it back and then they found the problem which also caused a check gas cap message and service engine soon light to come on . The problem was deteriorated rubber and plastic lines of the fuel pressure harness, GM Part #2450-6640! -
Related Items:
checked fuel pressure,only at 44 psi so I changed fuel pressure regulator. now it's at 50 psi. my car calls for 53-59 psi. only regulator I could find is rated for 50 p...
When I first found it I turned it on, then did something and shifted gears into reverse to find out the car was not on. So I thought I didn't start it. I started the car again, to find that it imme...
This has been an ongoing problem. First it appeared the engine would not run when it was hot. W...
...l, but starts right back up and runs smooth. I have replaced the throttle position sensor, the fuel pressure regulator and the idle air flow control valve and nothing has corrected the problem. Any advice?
I have changed the Crank Sensor, Camshaft Sensor, PCV Valve, MAF sensor, fuel filter, Oil Sensor Switch, Fuel Pressure Regulator, Spark Plugs, Spark Plug Wires and the car still won't start. I'm no...