front brake pads on 2003 Chrysler Sebring

what wrench is needed for front brake pad replacement?

by in Middletown, VA on August 27, 2009
1 answer
ANSWER by on August 28, 2009
After removing the wheel the caliper has a dampening spring clip on the out board side of the caliper, on the in board side there are two plugs that need to be popped out to gain access to the caliper slide pins. From the illustration it looks like an allen key is needed to remove the pin but there is no mention as to the size in the manual.
Related Items:
The pedal goes all the way to the floor and my wife is afraid to drive it. I have been changing my own brake pads and shoes for many years on many vehicles and have never had this before. I am not ...
I am trying to get a 1998 Sebring through inspection and it failed for the brake pedal travel to the floor. The brake pressure was good and the brakes seem to work normal. I replaced the fluid and ...
If the brake switch light is not properly adjusted, the brakes may be slightly applied when the pedal is not pressed, causing the front brake pads to wear prematurely. Also, the brakes may shudder ...
My car has a vibration in the front when I apply the brakes, to slow down or come to a stop.