The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.
Problems for specific Ford Ranger years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2000 Ford Ranger problems
If you experience cold starting problems, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steadily and run when the accelerator pedal is not pressed.
If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.
The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.
The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.
Moisture inside the rear brake drum assemblies can cause the rear drum brakes to grab, or lock when first driving. Inspect the rear brakes, replace the rear shoes as needed, and make any adjustments. The back side of the backing plate needs to be sealed where moisture can get into the drums to prevent this from recurring.