The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.
1998 Ford Ranger Problem Reports
Newest 1998 Ford Ranger Problem Reports
If you experience cold starting problems, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steadily and run when the accelerator pedal is not pressed.
The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.
The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.
The battery light may illuminate on the instrument panel because the alternator wire harness connector is damaged. A new connector kit is available and should be installed to correct this concern.