ran out of gas but check engine light came on first. the shop gave codes and reset light still on...
Q&A
Ask Your QuestionAll 1997 Ford Ranger
Question
have codes po301 cyl po171 lean b1 what repairs should be made?
Question
my heater wont get warm anymore but my temp hand stays at normal.whats wrong???
its never happened before...just after being gone 30 min i noticed it wouldnt heat up
Question
when reaching speeds over 50mph drive is sluggish and O/D light comes on?
auto trans, rear 2wd, 151k miles. OD light comes on as I approach speeds over 50mph. It feels as ...
Question
my truck got very very hard to shift into gear and now it wont shift at all.
I smell some burning under the hood when i tried to make it home.I could not get any power to go ...
Question
I have a problem with smelling gas when I shift gears from first to fourth gear.
I was told it was a air leak problem,but what does an air leak have to do with the smell of gas. ...
Question
my ranger 2.3l 2wd it all started with the starter relay i could not start it
with the key so i used a remote switch hooked up to the relay then that started to not work now...
Question
Why is it not getting fuel?
I have changed the fuel filter and pump and it now has a code p1131.
Question
Received codes P0172 System Rich Bank One, P0306-P0305, P1151H02 and P0420-
P0420-Bank One cap efficiency, P0172 System Rich bank one. Have replaced ignition coil,spark plug...
Question
O/D light comes on and stays on until I turn off and restart the engine.
There doesn't seem to be any other problems.
Question
dome light stays on when you shut door
took fuse out put back it worked for 2week then did it again took fuse out again and it worked fo...
Question
What is the procedure for replacing the Water Bypass Tube?
Cooling System began leaking through the Water Bypass Tube.
Question
belt not lining up
I replace timing belt on my ranger.put everything back together and my serpentine belt does not l...
Question
noise under hood
there is a "ticking" sound coming from the area near the air-conditioning unit/power st...
Question
Hood Release not working
Hood Release not working. No tension in the cable though cable is intact and still attached. Cabl...
Question
constantly blowing heat
The heater is always working, am constantly getting heat.
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 wenyan |
| 3 ziptie12 | 8 goodguy |
| 4 ChevyASE | 9 tdtoolbox |
| 5 gearhead89 | 10 Jamesw |