The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.
Problems for specific Ford Ranger years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1991 Ford Ranger problems
If you experience cold starting problems, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steadily and run when the accelerator pedal is not pressed.
If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.
it seems to bog down when u press on the accelerator if u go slow i mean real slow it does ok also seems to bog down when it reaches 3k rpm like its starving for fuel or getting too much
The battery light may illuminate on the instrument panel because the alternator wire harness connector is damaged. A new connector kit is available and should be installed to correct this concern.
Need to replace heater core as it's leaking into cabin floor in 1991 Ford Ranger. What are the steps to avoid trouble down the road.