A creak/pop noise while turning may mean that updated steering rack bushing tubes need to be installed.
Problems for specific Ford Mustang years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2007 Ford Mustang problems
The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.
The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.
The battery light may illuminate on the instrument panel because the alternator wire harness connector is damaged. A new connector kit is available and should be installed to correct this concern.
4.0L V6 engines may develop a buzzing type noise from the upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.
If a squeaking noise is heard while turning the steering wheel, the outer tie rod ends may be worn and should be replaced.