2006 Ford Mustang Problem Reports

Newest 2006 Ford Mustang Problem Reports

Report A Problem

A creak/pop noise while turning may mean that updated steering rack bushing tubes need to be installed.

The adhesive holding the glass convertible window gives out and the window delaminates from the outer convertible shell. I used 3M VHB 2-sided adhesive tape (the same type that is used to hold glass panels to the outside of skyscrapers) to hold the window back in. It worked great, but long term effectiveness is still unknown.

the pins will pull out of the connector for the transceiver ring,the connector is under the dash right above where your shins are.the wires pull out due to tilting the steering wheel and not enough slack in the harness.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.

4.0L V6 engines may develop a buzzing type noise from the upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.

If a squeaking noise is heard while turning the steering wheel, the outer tie rod ends may be worn and should be replaced.