Close

2005 Ford Mustang Problems

RepairPal has identified the most common problems with the 2005 Ford Mustang based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 2005 Ford Mustang
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
7
Known Problems

The 2005-2009 Ford Mustang with manual temperature and fan controls may have problems with the the blower motor only blowing air on certain settings. Most commonly the fan will only run on the highest setting. This is a well documented problem, and is caused by a failing blower motor resistor.

Correcting the problem is straight forward, and requires replacement of the small resistor. The resistor is normally found behind the glove box, next to the blower motor.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

If a squeaking noise is heard while turning the steering wheel, the outer tie rod ends may be worn and should be replaced.

A creak/pop noise while turning may mean that updated steering rack bushing tubes need to be installed.

4.0L V6 engines may develop a buzzing type noise from the upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.

The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.