A creak/pop noise while turning may mean that updated steering rack bushing tubes need to be installed.
Problems for specific Ford Mustang years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2000 Ford Mustang problems
the pins will pull out of the connector for the transceiver ring,the connector is under the dash right above where your shins are.the wires pull out due to tilting the steering wheel and not enough slack in the harness.
The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.
It is not uncommon for the intake manifold and/or valve cover gaskets to develop a coolant or oil leak. Leakage from the intake manifold may result in coolant in the engine oil. Coolant mixing with the engine oil severally impacts the lubrication ability of the oil. Internal engine may result if this condition is not repaired promptly.
The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.
If a squeaking noise is heard while turning the steering wheel, the outer tie rod ends may be worn and should be replaced.