2007 Ford Freestyle Problems
RepairPal has identified the most common problems with the 2007 Ford Freestyle as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The 2005-2007 Ford Freestyle with automatic climate control may have a problem with frequent fan speed changes when using the heater or air conditioner. Normally, the fan speed changes only to maintain a selected temperature, but when the fan speed changes frequently and needlessly, there is an issue with the fan speed control unit.
The fan speed control unit, sometimes erroneously called the blower motor resister, regulates the speed for the blower motor in order to maintain the temperature set by the driver. When it fails, the fan will run at random settings, and the climate control will be inaccurate.
Note: this does not affect the temperature of the air that comes from the vents, it affects the amount of air that comes from the vents.
The repair is simple, and quick. The control unit is located behind the glove box in most models, and removal and installation takes only minutes.
Also note: this only applies to vehicles with single or dual automatic climate control.
The 2005-2007 Ford Freestyle with manual temperature and fan controls may have problems with the the blower motor only blowing air on certain settings. Most commonly the fan will only run on the highest setting. This is a well documented problem, and is caused by a failing blower motor resistor.
Correcting the problem is straight forward, and requires replacement of the small resistor. The resistor is normally found behind the glove box, next to the blower motor.
If the rear brakes wear out abnormally fast, this can be caused by defective rear brake pads. The rear wheels may also appear to become excessively dusty. They should be replaced with revised brake pads, and all wheel drive (AWD) vehicles should replace front brake pads as well.
Electrolysis can cause repeated failures of the heater core and radiator. The diagnosing technician should check for voltage present in the coolant, with the battery disconnected, because electrical current in the coolant causes electrolysis. Corroded or deteriorated parts should be replaced, and the coolant should be flushed. Ground straps can be added to help prevent future corrosion of components.
Fitment and abrasion of wheel covers to the wheels can cause the wheel covers to make a ticking and / or clicking noise. Lubricating the back side of the wheel covers where they mate to the wheels should correct this problem.
Binding of the shifter slider can make the transmission shifter difficult to move. Replacing the bezel should fix this problem.