Ford has a manufacturing defect in the assembly of the body panels. The inner fender well and outside body panel area is filled with a solid foam insulation in an effort to avoid metal to metal contact. The foam material retains moisture causing premature failure of the interior wheel arch support as well as the exterior body panel. The repair is costly as it requires the removal of the rusted sheet metal and fabrication and welding in new so...
Problems for specific Ford F-350 Super Duty years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2008 Ford F-350 Super Duty problems
A defective driveshaft can cause a drone to be heard from the driveline area. The driveshaft should be replaced with a revised unit.
The high pressure diesel fuel injection pump may fail, resulting in a "no start" condition.
The cooler for the EGR valve can leak coolant internally, which causes white smoke to come from the tail pipe. Hot exhaust gases are cooled by the EGR cooler before being circled back into the engine.
Our technicians tell us the spark plugs in these engines can be very difficult to remove. Ford has issued a service bulletin (08-7-6) to address this issue, which includes a recommended procedure on how to remove the plugs. Failure to follow the recommended procedure can result in the one or more spark plugs breaking off in the cylinder head.
The recommend procedure is as follows. Using this procedure will greatly reduce the chance of breaking a spark plug.
1. Break the spark plugs loose when the engine is warm.
2. Turn each plug 1/8 to 1/4 turn and soak the treads with 1/2 to 3/4 teaspoon of Motorcraft Carburetor Tune-Up Cleaner or a quality penetrating oil. Do not try to remove the plugs at this time.
3. Let the threads soak for at least 15 minutes.
4. After the soak period, tighten and loosen each spark plug, working it back and forth until the turning effort is reduced. Then, you can remove the spark plug.
There are special tools available to remove the broken spark plugs and repair shops will often charge additional labor time, over and above the quoted spark plug replacement cost, for the removal of each broken spark plug.
The rear sliding glass window may stop working, or binds in motion. The power slider cable binds causing slow, or no operation. The glass assembly will need to be replaced, the cable is included in the assembly.
A leak in the exhaust down pipe and cause smoke to be seen around the front of the vehicle and engine compartment, and exhaust fumes in the cab. The exhaust down pipe should be replaced.
If the driveline angle is out of adjustment, it can cause shuddering from the vehicle when accelerating from a stop. The driveline angle should be adjusted to reduce vibration in most driving conditions.
If the engine cranks but will not start, this may be caused by damaged wiring to the high pressure fuel pump. Wiring to the pump can be chafed, which causes the pump to stop working. The chafed wires will need to be accessed and repaired.
Software enhancements are available to remedy inconsistency and confusion about the Diesel Particulate Filter (DPF) cleaning cycle - “Regeneration” mode. The Powertrain Control Module (PCM) will need to be reprogrammed to add several enhancements, including a more reasonable driving experience during the cleaning cycle and instrument cluster notifications of the cleaning status.