2009 Ford F-250 Super Duty Problems
RepairPal has identified the most common problems with the 2009 Ford F-250 Super Duty as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Software enhancements are available to remedy inconsistency and confusion about the Diesel Particulate Filter (DPF) cleaning cycle - “Regeneration” mode. The Powertrain Control Module (PCM) will need to be reprogrammed to add several enhancements, including a more reasonable driving experience during the cleaning cycle and instrument cluster notifications of the cleaning status.
The cooler for the EGR valve can leak coolant internally, which causes white smoke to come from the tail pipe. Hot exhaust gases are cooled by the EGR cooler before being circled back into the engine.
The 2008-2010 Ford F-250 with automatic climate control may have a problem with frequent fan speed changes when using the heater or air conditioner. Normally, the fan speed changes only to maintain a selected temperature, but when the fan speed changes frequently and needlessly, there is an issue with the fan speed control unit.
The fan speed control unit, sometimes erroneously called the blower motor resister, regulates the speed for the blower motor in order to maintain the temperature set by the driver. When it fails, the fan will run at random settings, and the climate control will be inaccurate.
Note: this does not affect the temperature of the air that comes from the vents, it affects the amount of air that comes from the vents.
The repair is simple, and quick. The control unit is located behind the glove box in most models, and removal and installation takes only minutes.
Also note: this only applies to vehicles with single or dual automatic climate control.
The 2004-2010 Ford F-250 with manual temperature and fan controls may have problems with the the blower motor only blowing air on certain settings. Most commonly the fan will only run on the highest setting. This is a well documented problem, and is caused by a failing blower motor resistor.
Correcting the problem is straight forward, and requires replacement of the small resistor. The resistor is normally found behind the glove box, next to the blower motor.
If the engine cranks but will not start, this may be caused by damaged wiring to the high pressure fuel pump. Wiring to the pump can be chafed, which causes the pump to stop working. The chafed wires will need to be accessed and repaired.
The rear sliding glass window may stop working, or binds in motion. The power slider cable binds causing slow, or no operation. The glass assembly will need to be replaced, the cable is included in the assembly.
If the driveline angle is out of adjustment, it can cause shuddering from the vehicle when accelerating from a stop. The driveline angle should be adjusted to reduce vibration in most driving conditions.