» » »

Problems for specific Ford F-150 years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 2006 Ford F-150 problems

 

Verified for the Ford F-150

Intermittent rough idle may be caused by the EGR sensor sticking, causing the EGR valve to stay slightly open. The valve and sensor must be replaced together to correct this concern.

19 Reports
Me Too

Verified for the Ford F-150

There is a technical service bulletin for the V8 engines regarding a possible problem with the spark plug being ejected from the cylinder head, damaging the threads in the spark plug hole. If the vehicle is under warranty, cylinder head replacement is recommended. If the vehicle is out of warranty, Ford authorized the use of a specific thread insert to repair the head.

30 Reports
Me Too

Verified for the Ford F-150

The engine oil pan gasket can develop a leak. Leaking oil may accumulate on the exhaust system resulting in a burning smell. Replacing the gasket should correct this leak.

27 Reports
Me Too

Verified for the Ford F-150

On higher mileage vehicles, one or more EGR orifice in the intake manifold may plug with sludge. This can cause the engine to misfire when first accelerating because too much exhaust gas is directed into the cylinders where the orifice is not plugged. Cleaning the clogged passages should correct this concern.

11 Reports
Me Too

Verified for the Ford F-150

Our technicians tell us the spark plugs in this engine can be very difficult to remove. Ford has issued a service bulletin (08-7-6) to address this issue, which includes a recommended procedure on how to remove the plugs. Failure to follow the recommended procedure can result in the one or more spark plugs breaking off in the cylinder head.

The recommend procedure is as follows. Using this procedure will greatly reduce the chance of breaking a spark plug.

1. Break the spark plugs loose when the engine is warm.
2. Turn each plug 1/8 to 1/4 turn and soak the treads with 1/2 to 3/4 teaspoon of Motorcraft Carburetor Tune-Up Cleaner or a quality penetrating oil. Do not try to remove the plugs at this time.
3. Let the threads soak for at least 15 minutes.
4. After the soak period, tighten and loosen each spark plug, working it back and forth until the turning effort is reduced. Then, you can remove the spark plug.

There are special tools available to remove the broken spark plugs and repair shops will often charge additional labor time, over and above the quoted spark plug replacement cost, for the removal of each broken spark plug.

12 Reports
Me Too

Verified for the Ford F-150

An illuminated Check Engine Light could indicate that one or more of the ignition coils has failed due to excessive spark plug gap. To fix this problem, the ignition coils that have failed, the spark plugs, and all coil boots should be replaced.

46 Reports
Me Too

Reported by cimtow and 8 others for the Ford F-150

Turned on heater and got cold air. set it to 90 and the the temp guage got to half and only got a small amount of heat. vehicle started to have windows fog had to turn on A/C to clear them. It was working fine just two days ago last time used.

9 Reports
Me Too
Ask a Question