My 98' Ford F 150 4.2 was given newly rebuilt/shaved heads as one was cracked beyond saving....
Q&A
Ask Your QuestionAll 1998 Ford F-150
Question
If the vacuum operated actuator on intake is bad, how much to replace?
Question
the heater stays on after u turn the truck off can it be multifunction switch
I am having trouble with things cutting in and out the wipers, windows, inside lights and now the...
Question
What should I check first if my wiper/washer is not working?
They do not operate at all
Question
Key won't turn
Have not had any problems before today and now my key wo'nt turn in the ignition. Works in t...
Question
is there a check valve in the heater hose that goes to heater core
i can blow through one way but not the other and theres a factory clamp on the hose witch is hold...
Question
4x4 vacuum actuator not moving
lost 4 wheel peel. turn the switch and the light on dash comes on, can hear something engaging o...
Question
check engine light is on each time i take to aut zone for code reading i get a
a diferent code reading i replaced fuel filter but says o2 sensors and hi an low fuel pressure wh...
Question
2 NEW STARTERS IN P/U TRUCK. NOW THE STARTER SPINS AND ENGAGES ONCE IN A WHILE.
I CRANK IT, THE STARTER SPINS. DOES IS LIKE 5-6 TIMES THEN CATCHES AND TRIES TO START. THEN SPI...
Question
repair cost for compressor, dryer,and high pressure line, replacement.
and recharge ac system on a 1998 ford f-150, 4.2 six cylinder.
Question
How to replace oil pan gasket
My f150 leaks oil alot. I can not tell where it is coming from but assume there is a leak in the...
Question
Was running turned it off now it will not start. It's getting gas and spark
Went into store came out will not start
Question
1998 ford f 150 the heater doesnt work.It blows cold air instead of hot
cold instead of hot and kind of warm when turned to aircondision.Blend door is fine coolant is fi...
Question
What would be the problem if you try to start the truck and it just clicks.
We put a different fully charged batter in it & it just clicked when we tried to start it.
Question
oil pressure guage doesnt read anything
started truck today and oil pressure light came on dash board. guage wouldnt register at all. fir...
Question
how to locate #4 cylinder
got the code po304 but i dont know which is the #4 cylinder.
i need advice on how to find it
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 wenyan |
| 3 ziptie12 | 8 goodguy |
| 4 ChevyASE | 9 tdtoolbox |
| 5 gearhead89 | 10 Jamesw |