should there be continuity between fuse terminals in power distribution box with large fuse removed?
Q&A
Ask Your QuestionAll 1997 Ford F-150
Question
pcm fuse in power distribution box blows when ignition is turned on.
Replaced pcm relay.
Question
Well i was woundering what causes my truck to not get spark. It cranks
I ran fine other day then died
Question
The truck is a 2 WD.The turn signals don't work when the tilt steering is down.
Is it the turn signal switch? And how much is the average repair cost? If the steering wheel is a...
Question
i just purchased a 1997 ford f150 with the 5.4 triton
and bringing it home it started loosing acceleration and started jolting and chugging badly it di...
Question
only code is bank one lean, replaced fuel pump,truck starts but only if pedal is
pressed half way will not idle have to pat pedal to keep running,when it dies sounds like it pops...
Question
truck wont start after running out of gas. checked fuel reset battery level good
Added gas and rolled to level ground. Tapped starter tried jump.
Question
what would cause the oil pressure to drop very low when the engine idles running
its has around 40lbs at idle 2 or 3 lbs the engine has 125000 mile on it very will takin care of
Question
97 f150 4x4 front hubs wont engage
shifts to 4 wheel drive but front hubs wont lock
Question
I'm getting vapors coming thru the vents, i used stop leak to seal a leak
Stop leak was added to radiator 2 days ago. When fan is turned lots of vapors shoot out, smells l...
Question
code 455 after replacing intake gaskets what do i need to look for to fix?
replaced gas cap replaced cat. convertor. replace the vavle at cannister. had evap test can fin...
Question
can a evep leak becomming from the erg switch/vavle on the intake
Had someone replace the upper & lower intake gasket recently and soon after that we had a cod...
Question
my truck did not pass the smog test because of emissions
i try to read the codes but there was no codes for emissions what could be the problem truck is ...
Question
engine cranks over but will not start. there is no spark.
will not show any code. what would be the most common problem?
Question
my gear shift lever does not line up with the dashboard
auto trans
This week's top 10
| 1 globalhelper | 6 FREDDY BLUE |
| 2 pushrod | 7 csubak30 |
| 3 ziptie12 | 8 ebans777 |
| 4 ChevyASE | 9 gearhead89 |
| 5 wenyan | 10 corvairart |