Should this be an easy fix that i can do myself?
Ford Q&A
Ask Your QuestionAll 1996 Ford F-150 questions
Question
fluid leaking from on rear axle right pat drive shaft. what gasket do i need
Question
Run and starts perfectly, but no power at full throttle.
Generating p0171 and p0174 on a 4.9l. Idles perfectly cold fast, hot 650, smooth. No misses, no s...
Question
starts great first time i start it but every time after that i have to hold it
my 96 f-150 4x4 has ran great since i bought it 3 years ago. I went to town the other day and it ...
Question
truck won't start when warmed up without putting gas to floor
no codes came up when scanned
Question
Why won't the serpentine belt go on??????
I changed the water pump on my f150 and now i can't get the belt back on. I'm following...
Question
will a egr valve fix a p1400 code
i have a code that reads p1400manufactors controlled auxillaryemission controls will a egr valve ...
Question
will a eng coil fix a p1351 code
i have replaced the ignition module
Question
i would like to fix my trouble codes. but dont know what parts are they.
and dont know wher ther located at. codes p1131,p0175,p0133,p1131,p0174. can u show me wher this ...
Question
Aout a noise inside the dashboard
i heard a beeping noise, that goes six times and stop and start back up within three minutes late...
Question
Where is the Bank 1 and Sensor 1 located?
Is bank 1 left or right, and sensor 1 pre-cat? I have a P0133 code.
Question
I think I need a new alternator for my F150. Please read below and help. Thanks
I have a 1996 Ford F150, 6 cylinder, 4.9L engine, that needs a good tune up and possibly an alter...
Question
master cylnder
i have a 1996 ford how do u blead the master cylnder. Is the line going to the trans have to be ...
Question
what makes engine mifire at all speeds
engine has a slight miss every 15 seconds at idle. at all driving speeds the engine misfires badl...
Question
My truck is leaking from the front gas cap, even while it is parked.
It occurs sparingly, never know when. The truck could sit for days and all of a sudden gas is lea...
Question
how to take off and replace harmonic balancer
mech. told me i need to replace it. ruber seal was trash
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 Hal... |
| 3 ziptie12 | 8 elk |
| 4 milesauto | 9 gearhead89 |
| 5 ella1234 | 10 Eric Sevim |