» » »

Problems for specific Ford Explorer years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 2006 Ford Explorer problems

 

Verified for the Ford Explorer

The rear window wiper may not fully contact the rear window. Our technicians tell us that replacing both the wiper blade and wiper arm will generally correct this issue.

54 Reports
Me Too

Verified for the Ford Explorer

A coolant leak may develop from the radiator. Ford has released and updated radiator and powertrain control module (PCM) software update to address this issue. The software update includes revised cooling fan operating parameters. Failure to complete both service procedures may result in repeated radiator failures.

9 Reports
Me Too

Reported by Topsy1 and 9 others for the Ford Explorer

My 2008 Explorer radiator failed on its own. I later noticed that my fan will always run trying to keep up with the heat generated. I also had to keep topping coolant. On making a little research, i found out that its a common problem with 2006 thru 2008 ford explorer and so many people had replaced their radiator. The cost of doing this can set you back almost a thousand bucks. I did replace the leaking radiator along with the reservoir and t...

10 Reports
Me Too

Verified for the Ford Explorer

A failed heater blend door or actuator can cause the temperature control for the HVAC system to stop working. A clicking sound from the dash area would commonly indicate an actuator fault. If the heater gets stuck on the hottest setting, the heater blend door may be broken requiring replacement of the heater box to repair the issue.

217 Reports
Me Too

Verified for the Ford Explorer

A cosmetic crack may develop on the plastic liftgate trim panel. Ford has released a service procedure to replace the applique without damage the the liftgate glass.

411 Reports
Me Too

Verified for the Ford Explorer

Our technicians tell us the spark plugs in this engine can be very difficult to remove. Ford has issued a service bulletin (08-7-6) to address this issue, which includes a recommended procedure on how to remove the plugs. Failure to follow the recommended procedure can result in the one or more spark plugs breaking off in the cylinder head.

The recommend procedure is as follows. Using this procedure will greatly reduce the chance of breaking a spark plug.

1. Break the spark plugs loose when the engine is warm.
2. Turn each plug 1/8 to 1/4 turn and soak the treads with 1/2 to 3/4 teaspoon of Motorcraft Carburetor Tune-Up Cleaner or a quality penetrating oil. Do not try to remove the plugs at this time.
3. Let the threads soak for at least 15 minutes.
4. After the soak period, tighten and loosen each spark plug, working it back and forth until the turning effort is reduced. Then, you can remove the spark plug.

There are special tools available to remove the broken spark plugs and repair shops will often charge additional labor time, over and above the quoted spark plug replacement cost, for the removal of each broken spark plug.

5 Reports
Me Too

Verified for the Ford Explorer

A ticking noise may develop from the engine due to a cracked exhaust manifold. Damaged exhaust manifolds will require replacement to correct this issue.

13 Reports
Me Too

Verified for the Ford Explorer

The composite (plastic) intake manifold may crack near the thermostat housing and cause a coolant leak. Ford released an updated manifold that was reinforced to prevent a recurrence. No recall was issued for this problem but Ford did extend the warranty to seven years on some models from the date of purchase.

24 Reports
Me Too
Ask a Question