1997 Ford Explorer Questions
Unanswered 1997 Ford Explorer Questions
Ask a Question
In front of the back tire. And it only does it when the car is on. Stops when car is off.just replaced thermostat. I have a picture but can't load it. It is a part underneath the car that has a bunch of holes in it?
The car make a clicking sound when I turn the ignition but it want start. I had this problem before and I had got it checked and found out that it was the starter so I got a new starter. But when I went to pick it up ...
Heater and defroster works fine. Ac only works on max and sometimes there's a thump sound that comes from passenger floorboard when I turn ac on.
top hose colapsed when started
you still have to step on the clutch pedal to "shift" but no shifting going on. 1-5 or reverse, and when shift into gear you can then release the clutch and the car still runs. so basically stuck in neutral.
report states the Catalytic Converters and Evaporative System "NOT READY" and told it will happen when battery has been disconnected which was replaced 2 days prior to inspection. How do I fix problem to get reinspec...
Before it was just leaking fluid not oil, and stalling a little for a few days,but now the engine light is on and it smokes and stall more often
The transmission oil achieved very low level due to leaking (gasket) .About 2 months after just filling it up (Mercon V) this problem appeared. Once it starts going forward the transmission (automatic) works fine, but...
What would be the approx. cost to replace front rotors (pad are good) and ball joints 4WD both sides lower..
If my 1997 Explorer has good front brake pads but may need front rotors is it ok to replace rotors only and leave the pads? Also if you replace ball joints do you have to replace all balls joints?
However, when I turn on MAX AC, cool air comes out but it's not very cold. Compressor is working fine. Also, the driver side vents are very weak.
I have changed the plugs and wires. replaced the cmp sensor. replaced the epc solenoid and filter in trans.
how two remove an replace driver door power door lock and handle with a dioagrame