1995 Ford Explorer Questions

Answered 1995 Ford Explorer Questions

Ask a Question
View:RecentAnsweredUnanswered
changed fuelpump,fuel filter,relay,coil pack. when it runs it runs good. what am I missing?
My driver side windshield wiper stopped working. The gear that the wiper blade fits on turns freely and it shouldn't. How do I fix the gear - I've been told something has just slipped and can be easily fixed?
I need to replace my high mounted brake light on my 1995 explorer and I have a 1996 explorer that I can take parts off of.
I have an Explorer with 4.0 V6. The engine has 190,000 miles on it. The timing chain sounds healthy. Does anyone know how long this timing chain is expected to last?
This problem just started, but when I turn my heat or ac controls on, a very loud screaching noise occurs and will stall out engine, if not immediately shut off.
Do I have to get it repaired or can my husband repair it. We had this happen a few years after our Explorer was new and it was very costly. At that time it was under warranty and we still had to pay for the labor, a l...
How much should I expect to pay at a Ford dealership to replace several dashboard lamps? Can I do this myself? Would an independent auto repair shop be a better choice. My current shop of choice has declined the rep...
low beams don't work but high beams do if i pull back on stick. i have changed the headlight switch,the mulitswitch and check all fuses and relays. is there something else ???
I have replace the bulbs and fuses and looked all over for a burnt wire and it still doesn't work.
where is the fuel pump switch
I am working on yjis for a friend it has good fuel presure and spark it pops and tries to start but won't start timing chain is mark to mark and changed the plugs ?????? 39 years on the line but been retired afew yea...
I believe I have to replace my ball joints because when I drive or even get into my explorer it makes a rattles alot. My tires get worn out quickly as well.
I was recently in a car accident on (1-22-2011) and was hit from behind. My rear bumper and the back door were damage and want to know a esitmated cost of how much it will be to get repaired.
is there a way to tell if the slave cylinder is bad? i replaced the pressure plate disc ,throw out bearing and clutch master cylinder. i have bench bled the master cylinder and pumped and bled the system several times...
when the truck is cold and i`m driving down the road the truck starts to bump almost like someone is tapping me in the bumper lightly mainly when i let off of the gas but when it worms up it runs good do you think it ...