1999 Ford Escort Questions
Answered 1999 Ford Escort Questions
Ask a Question
Do I need to clean the EGR valve?
Three things. Oil level a few inches above maximum; runs noisy, but always starts right up and inspite of noise, idles well. Noise isnot as loud inside the car. I hear no rods knocking. I think it's body noise, maybe a motor mount? Fan, heater, air do not
This car was a gift and I know it had previous front end body damage from a collesion which was supposed to have been repaired.
fine was running fine then began knocking at start up 1/2 hour later is it possibly the timing belt and how much damage would driving after that cause. car can still run rough and loud knocking
had idle pully,serpentine belt and waterpump replced. about 3 mths ago it would turn over but not crank. waited 8 hrs. it started fine. yesterday check engine light flashed 'bout 7 x then went out. should i be concerned for a timing chain?
car still runs,no noises but is idleling a little rougher than usual, no change in performance. made it back home, 20 mls, and light never came back on
I have an 1999 escort with original 60000 miles. What should be changed out at this time considering the age?
Not firing to the plugs
the motor starts right up, and at higher rpm;s seems fine. But if you take your foot off the gas it dies. wont idle at all. what could this be?
While driving it down the road the engine would shut off,it would start right back up, it did this for a week, now it will not start at all, befor it died i took to auto zone they said the crankshaft positioning sceno...
was driving on freeway. car just died. headlights work, but car won't start. checked the battery, starter, all fuses, everything is fine. when I turn the key nothing lights up on the dash. dash lights work when I turn...
car died while driving. made rattling sound. checked timing belt which was replaced less than 2 yrs ago. Tried to line up timing marks with socket & breaker bar. Motor would hang up and wouldn't move. Had to move back...
Timing belt less than 2 yrs old. Tried to line up timing marks but motor hangs up near that point. will not move unless I move it back and forth and then it slips by the mark. Don't remember this happening when I repl...