The trouble code is P0128 and the engine service light is ON
Q&A
Ask Your QuestionAll 2008 Ford Escape
Question
"Cooling system not reaching temperaturet to allow thermostat to pen" what cause
Question
why do door locks act up?
There are times that they will not lock or unlock! using the inside button or even the key pad?
Question
what did I do?
I started my vehicle in -40 weather this morning and it revved really high and started blowing oi...
Question
The compass direction on the clock display is wrong.
When I'm going south the display shows SW, when going east is shows south. How do I correct ...
Question
the sun roof will not open when i activate it
dealer claims i need new motor and cable - price 1400 to fix.
Question
need instrutions from (WSM)412-01 on how to replace right side actuator ?
How do I remove dash to get to the actuator?
Question
The interior fan does not run on #1 and #2 settings?
It works fine on #3 and #4 settings nothing on #1 or #2?
Question
Is there a oil cooler on an 2008 with tow package
Oil like fluid leaking out under the coolers dealer can not trace the sourse
Question
Is ABS module damage related to improper caliper installation?
My vehicle went to a car shop last week and received an installation of two replacement calipers ...
Question
How do you tighten the bolts on the front door.
The front door is loose and drops a little when opening. I can't find access to the bolts t...
Question
Power train light came on is it safe to drive?
Light came on suddenly and the vehicle seems to not shift properly
Question
Trying to remove my battery. I feel like a moron.
I have removed the piece across the top. There were several small bolts that seemed to hold the ...
Question
Need to reattach the rear view mirror
Rear view mirror detached when I touched it. How do I reattach it?
Question
steering
steering wheel jearks going down the road dont do it all the time but does a lot happens more at ...
Question
Need a schematic for upper steering shaft
The upper u-joint and steering shaft on my Escape needs to be replaced. I looking for a diagram ...
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 FREDDY BLUE |
| 3 ziptie12 | 8 gearhead89 |
| 4 ChevyASE | 9 ebans777 |
| 5 wenyan | 10 tdtoolbox |