The battery light would come on. When starting on the starter knocks.It would not start? Until I ...
Q&A
Ask Your QuestionAll 2001 Ford Escape
Question
Why would the 2000 Ford Escape drain its battery after 2 hours of use?
Question
New spark plugs,wires,injectors, coil,pcm still misfire and hes. Shop say valve?
Shop says 2500$ valve job? Is there any thing else it could be?
Question
Has anyone ever had a warped intake manifold?
I have replaced the O rings between the upper manifold before and when I took it apart the last t...
Question
at operating temp the truck stumbles at idle
I have a constant low vacuum at the EGR valve less than 5 Hg at idle, which it seems is enough to...
Question
trouble started as a P0401 EGR Low Flow
I changed all the vacuum lines, changed the ERG, and solenoid pump. The truck stumbles once i put...
Question
P0401 Changed ERG valve and Pump, replaced all vacum lines
Cleard the code but it still runs rough at idol, anything els to check?
Question
My wife's 2001 Escape has 175,000 miles. New plugs & coilpacks. Rough idle..
This has been a great vehicle for us but now it is idling rough in the mornings but is ok after w...
Question
idle problem when starting 2001 ford escape 6cyl 3.0 ltr
2001 ford escape runs very rough at cold start in the morning runs at very low idle and wants to ...
Question
I have a 2003 ford escape. my dashboard tacks goes crazy.
goes to 120 for 5 sec then to 0 for a few sec then back to normal. it started skipping and sputte...
Question
i cannot get front rotors off 2001 ford escape
i took calipers off and 1 1/4 nut off disc seems to be stuck?
Question
Is the orfice tube accessable from the engine compartment? Thank You.
Do I need to pull the evaporator to get to the tube? Please tell me it's not.
Question
Where is the expansion valve located on a 2001 Ford escape V6?
A/C intermittenly blows cold then hot. Suction line from port forward was cold but from port to a...
Question
idles rough at low rpm has codes po 352 and po453 had old code po113
idles rough at low rpm scan tool shows poor contibution from cylinder 2 and almost as bad with cy...
Question
How do you open doors with child safety feature on?
Have tried with remote,with key,and main controls.The child safety feature should let you open th...
Question
My fabric on the door panel is falling off. How do you replace it?
Should I have body shop replace or do it myself??
This week's top 10
| 1 globalhelper | 6 FREDDY BLUE |
| 2 pushrod | 7 gearhead89 |
| 3 ziptie12 | 8 tdtoolbox |
| 4 ChevyASE | 9 wenyan |
| 5 csubak30 | 10 ebans777 |