» » »

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Repairpal verified 2001 Ford E-150 problems

 

Verified for the Ford E-150

The spark plugs may become dislodged from the cylinder heads. A loud popping noise can be heard and a subsequent misfire experienced. The threads on the spark plug ports in the cylinder head(s) can become stripped or missing when the spark plug is dislodged. The threads in cylinder heads may be replaced using “Lock-N-Stitch” aluminum inserts. Our technicians tell us thread replacement is performed when the vehicle is out of base warranty. Vehicles under base warranty receive a new cylinder head.

26 Reports
Me Too

Verified for the Ford E-150

The Check Engine Light may illuminate, the engine may run rough and have misfires on acceleration. Commonly the ignition coils and/or the ignition coil boots are the cause of this problem. The rubber boot that insulates the coil to the spark plug can dry and crack allowing arcing. Inspect the coils and boots, and replace them as needed. Our technicians also recommend replacing the coil boots any time the spark plugs are replaced.

43 Reports
Me Too

Verified for the Ford E-150

The front end may make a rattle noise over bumps. There may be handling issues, and play in the front wheels on inspection. If there is up and down movement on the front wheels while the lower control arms are being supported, inspect the upper and lower ball joints for excessive play. These are prone to failure from moisture entry and lack of lubrication. The ball joints should be replaced as needed.

28 Reports
Me Too

Verified for the Ford E-150

If the slip yoke in the driveshaft is binding, it can make a clunking noise when pulling away from a stop. The slip yoke will need to be lubricated.

17 Reports
Me Too

Verified for the Ford E-150

Electrolysis can cause repeated failures of the heater core and radiator. The diagnosing technician should check for voltage present in the coolant, with the battery disconnected, because electrical current in the coolant causes electrolysis. Corroded or deteriorated parts should be replaced, and the coolant should be flushed. Ground straps can be added to help prevent future corrosion of components.

26 Reports
Me Too

Verified for the Ford E-150

A defective key-in warning chime switch can cause the ignition cylinder to bind from run to start and / or start to run movements. The key-in warning chime switch will need to be replaced.

5 Reports
Me Too

Verified for the Ford E-150

The Check Engine Light may come on with no driving issues noticed. If P0401, P0402, P1400 and / or P1401 are in memory, the Delta Pressure Feedback Exhaust Gas Recirculation (DPFE) sensor is at fault. The DPFE sensor should be replaced.

4 Reports
Me Too

Verified for the Ford E-150

This concern related to the 4R100 automatic transmission typically seen mated to the 5.4L V8. If the transmission does not shift correctly out of first gear, a “one-way” clutch inside the transmission may have failed. If the transmission fluid condition is good, and other failures are not found upon transmission tear down, the one-way clutch may be replaced along with the drum and friction plates. Our technicians note this is a major internal transmission repair.

1 Report
Me Too

Verified for the Ford E-150

Engine oil may leak externally from the cylinder head gasket. The gaskets were contaminated with metal debris from the factory – between the block and gasket and/or the head and gasket. To correct, the head gasket must be replaced and the mating surfaces on the cylinder head and block need to be inspected for chips or damage. In some cases the cylinder head will not be repairable and will need replacement.

32 Reports
Me Too
Ask a Question