» » »

Problems for specific Ford Crown Victoria years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 1990 Ford Crown Victoria problems

 

Reported by bmdouble for the Ford Crown Victoria

check wires in visor for visor lights,will chafe and short to ground over time and blow fuse. tape or heat shrink exposed wire to solve problem.

1 Report
Me Too

Verified for the Ford Crown Victoria

The EGR valve position (EVP) sensor can fail on this vehicle. The EVP sensor measures the EGR valve position and transmits the date to the engine control computer. If it fails, drivability and fuel economy can suffer, the Check Engine Light will commonly illuminate.

18 Reports
Me Too

Verified for the Ford Crown Victoria

It is not uncommon for the intake manifold and/or valve cover gaskets to develop a coolant or oil leak. Leakage from the intake manifold may result in coolant in the engine oil. Coolant mixing with the engine oil severally impacts the lubrication ability of the oil. Internal engine may result if this condition is not repaired promptly.

2 Reports
Me Too

Verified for the Ford Crown Victoria

The steering gear may have an internal problem that makes turning to one side difficult; it may need to be replaced. A wheel alignment is needed after the steering gear is replaced.

2 Reports
Me Too

Verified for the Ford Crown Victoria

The throttle position sensor (TPS) may fail. Common symptoms of a defective TPS can be rough idle, hard starting, hesitation on acceleration, poor fuel economy, and stalling.

1 Report
Me Too

Verified for the Ford Crown Victoria

If you experience difficulty starting the engine when cold, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steady when the accelerator pedal is not pressed.

3 Reports
Me Too

Verified for the Ford Crown Victoria

The battery light may illuminate on the instrument panel because the alternator wire harness connector is damaged. A new connector kit is available and should be installed to correct this concern.

4 Reports
Me Too

Verified for the Ford Crown Victoria

Certain police, fleet, and natural gas models may experience lower ball joint wear, requiring replacement of the front ball joints. Ford has issued a recall on certain vehicles for this condition. Please contact your local dealer for more information.

16 Reports
Me Too
Ask a Question