2000 Mazda B2500 Q&A

2000 Mazda B2500 Question: failures

i have a pick up mazda b2500 2000, when start de engine it failures, it shakes, but in a few minuts run very well. failures every time when i run it -
Answer 1
You have an engine performance issue that requires some diagnosis. Everything I suggest here will be more or less guess work - having the proper qualified technician inspecting your truck with a high grade diagnostic tool - that is what you really need. Start and stall, shaking then running fine after it warms up -- that's what I am taking from your post -- I would think of a possible sticking idle control valve, vacuum leak, even a MAF sensor issue or an EGR valve or EGR flow issue. If it did not clear up after a short bit, I would start looking at fuel pressure and tune up items as well. Since I have no clue of the truck's history, I'm left to recommend nothing further unless a diagnosis is performed. Good luck! -
Related Items:
Failed Emissions Test. Engine light on. Cannot register with failed emissions test. Any ideas. I am unemployed and cannot afford to pay someone to repair???????
The clutch on my truck is VERY stiff, and heavy. It was replaced 3 to 4 years ago. Ive heard I could drain a little fluid out of it. Ive also heard that it may be the clutch plate... I dont know mu...
When it stalls, no compression, and starter seems to go very fast. The check engine light does not staying on after it restarts. No codes. Seems to have much less power. It stalled 3 times last...
When u turn the key the engine will turn over but not start, but if I press the gas pedal while doing so it starts BUT if I immediately let off the gas pedal it will just die again. I have to turn ...