On vehicles with intermittent windshield wipers, the wiper motor circuit board may fail and cause the wipers to stop working at times. Replacing the circuit board should resolve the issue. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
Windshield Wipers May Fail Due to Faulty Wiper Motor Control Board on Isuzu Hombre
Average mileage: 122,566 (78,000–152,700)
8 people reported this problem
4 people shared problem details
2000 Isuzu Hombre137,000Visitor
only have fast and medium speed options of the wind sheild wipers. cleaned plug worked for awhile then quit again
1997 Isuzu Hombre78,000Visitor
Wiper motor did not function when activated, no noises could be heard. Manually pulling the wiper blade an inch would activate the wiper motor for it's full cycle, sometimes allowing it to continue operation, but sometimes only for a single cycle. Replacing the pulse board module solved the issue, no other repairs done.
1997 Isuzu HombreVisitor
Intermittent Wiper and I have found out that the PCB broken connecting the motor terminals, i just clean the pcb solder it with jumper to have a stronger connection. it is now 3yrs since and still working.
1996 Isuzu Hombre152,700Visitor
Replaced motor and still have same problem. Going to locate the circuit board to replace.
After cleaning all the ice, my wipers don't move at all. Is there maybe a fuse I could look int...
Wipers only run in mist mode or when you activate the washer pump
The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor res...
I just changed the water pump, thermostat and temperature switch because I had a leak and was t...
The distributor may develop internal faults. This can cause a rough running engine or stalling...