1993 Jeep Grand Cherokee Q&A

1993 Jeep Grand Cherokee Question: Factory Alarm Problems

Factory alarm system has randomly engaged stopping fuel flow and preventing re-start. Re-set randomly works. Have disabled at overhead console but still experience random stops. How do I disable perminantly? -
Answer 1
Unfortunately, You cannot disable the factory alarm system. It is programmed into the Powertrain Control Module. Possible other causes are Hood, Door, Liftgate or switches. Powertrain Control Module (PCM) Key lock cylinder switches. -
Comment 1
Is it possible that it could be the chip in the ignition key? I have the same problem on my 96 pontiac grand am gt 3100 -
Related Items:
just started 10-18-2010 wipers and washer and alarm system don't work have replaced 10 amp fuse as per manual no change also pulled apart pcm and used dielectric on pins replugged together and stil...
I have already replaced my remote key battery. Last time my remote didn't work (had to buy a new one)I was still able to get inside and when I turned on the ignition the alarm would stop. This tim...
were is the anti theft alarm at
i have a 98 jeep grand cherokee when i purchased it the factory alarm worked when i locked the door before exiting the light would start flashing and the alarm would be armed then it started only a...
I would like to know how to disarm this device. I must use the electronic key buttons to un lock the car doors. At times this does not work especially if car is left in the sun at a lengthy time. I...