Error Codes on 2004 Chrysler Sebring

My vehicle was diagnosed with error code P0700 and P01776. What does this mean

by in Sacramento, CA on May 06, 2010
1 answer
ANSWER by on May 08, 2010
Automatic Transmission DTC P1776 = Solenoid Switch Valve Latched in LR Position. Engine Performance Gas DTC P0700 EATX Controller Diagnostic trouble Codes Present. Take your car to a qualified technician, find shops here; http://repairpal.com/directory?address=95831&car_brand_names=Chrysler
2 people like thisFlag inappropiateReply
Related Items:
Hard to start, rough idle or will not, hesitation, error code 0300. Once up past idle speed of maybe 1200 rpm runs fine. 2.4L
I have a steady check engine light with 3 codes. P0304 misfire in cylinder. then 2 codes about intake and exhaust cam sensor slow response. it almost stalls at idle speed.
While idling, either in park or with my foot on the break my speedometer jumps like i'm going between 10-20MPH. I noticed it tends to do it more often when the heat is on. I was told it would be th...
car just didn't start one day. replaced starter (it was rough inside anyway) when i hooked a new battery up i noticed a strong spark off the negative. the panel says "no bus" after several tries. h...
my 04 sebring rough idle after t-belt change (complete kit) installed and tune ie plugs, wires, no. 4 fuel injector, ignition coil, spark plug boot and vavle cover casket replaced. FS installed t-b...