engine stops running on 2000 Mitsubishi Galant

replaced timing belt car runs excellent,however at an idle it stops running and at a stop sign or stop light it dies out can you help me!

by in Pueblo, CO on January 25, 2011
1 answer
ANSWER by on January 26, 2011
Did you disconnect the battery or did it go dead while you were replacing the timing belt on you 2000 Mitsubishi Galant? If so the computer may have lost is learned idle speed. Please review the following RepairPal article for more information - http://repairpal.com/memory-loss-associated-with-battery-replacement
Related Items:
My engine stopped running today when going down the highway at 90mph, it gave no warning of any trouble. Temp was normal, full tank of gas, engine didn't sputter or give any signs of stalling. I we...
The engine may develop a low idle or stalling condition due to a failed idle air control valve. Our technicians tell us the replacement of the faulty valve is required to correct this condition.
While stopped in gear for a turn the engine began to run rough. Upon service the valve cover gasket, spark plugs, spark plug wires, coils were replaced. The fuel injectors cleaned. Air filter repla...
Just had my timing belt replace, now my car will turn off at a stop sign or in traffic, will do this randomly.
The Check Engine Light may illuminate due to one or more engine vacuum leaks. Our technicians tell us these leaks can be caused by damage to seals and/or vacuum hoses as a result of to much ethanol...