Problem Reports

Chrysler Town & Country

Report: Engine may not crank due to connection at starter

Chrysler Town & Country Problem

6 Reports

Me Too

Model Years Affected: 1990, 1991, 1992, 1993, 1994, 1995

An improperly-seated connection on the starter (coming from the battery) may cause the engine not to crank. Plastic must be ground off the cable terminal so it can sit flat and flush.

Add to My Checklist

Find a Shop

Follow this Problem Report Unfollow this Problem Report

Related Items:

Why does my engine miss badly
1999 ford f150 engine mises badly when accelerating. new plugs, wires, and coils have been installed and still the same problem
Q&A > Chrysler > 2003 Chrysler Town & Country
Loud engine knock
Loud engine knock. Told by mechanic this is a blown rod and engine replacement required. 107.0...
Q&A > Chrysler > 2002 Chrysler Town & Country
CHECK ENGINE LIGHT STAYS ON IN MY 2005 T&C VAN
Had major tune up a month ago. Replaced Oxygen sensors, plugs,and cables. Since that time I have seen the check engine light come on and yesterday it has jsut stayed on all the tiem.
Q&A > Chrysler > 2005 Chrysler Town & Country
starter moter will not rotate due to no power going to starter solinoid
I have verified that the battery, relay,connections and starter moter and solinoid are all good. the funny thing about this is that the steering wheel will no...
Q&A > Chrysler > 2003 Chrysler Town & Country
car was running fine stopped shut engine down and then tried restart .Would not
would not start turns over then there is a clicking noise and will not start
Q&A > Chrysler > 2003 Chrysler Town & Country