Get the latest advice about your car

Get Started
Advice » Q&A » 2006 Ford Expedition

Q&A

Ask Your Question

2006 Ford Expedition

Question: Engine failsafe warning is coming on and shutting down the engine

Question

Visitor, Chesapeake, VA, December 15, 2010, 08:48

While driving at slow speeds, the engine failsafe warning will sometimes come on and as a result, the engine will cut off. It initially happened four months ago but has been happening more often recently. To resolve the problem, I turn the engine off, remove and then reinsert the key and the engine starts right back up. When it first happened I took the vehicle to the dealership and they ran a diagnostic test on the engine that revealed no problems. Was advised that the sensor that controls the failsafe is located in the throttle body and that it might be going bad however, was advised that you cannot replace just the sensor but would rather need to replace the entire throttle body because the sensor is part of the throttle body. Is that correct? Any suggestions?

1 Answer
Flag This
  • Answer #1

    DaveJHM December 15, 2010, 22:33
    Profile_thumbnail
     Master

    It's true that the throttle body is an assembly. But you said the engine will "cut off"? Do you mean it runs, but will not accelerate? Or it stalls?

    ETB issues will not cause a stall. Just a no acceleration issue. A stall driving sounds more like a fuel pressure issue.

    Reply
    Flag This
Answer Ranks