Q&A

1999 Mercedes-Benz C230

Question: Engine Control Light

Question

dwopjr, Washington, DC, August 06, 2009, 14:03

 Rookie

Hi..My light went on after my gas tank top broke. I replaced it and the light remains on. How do I shut it off without going to a dealership? The car works fine and was in for servicing a few weeks ago.. thx, Dwopjr

2 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  dandd August 06, 2009, 16:27
  

   Master

  If the Fuel Cap was the only problem, the Check Engine Light should go off by itself with in 2-3 days. Did you get a genuine Mercedes Cap? Is the filler neck distorted in any way, so the new Fuel Cap does not seal? Good Luck!
  Reply
  Flag This
  Like | 1 person likes this1
• Answer #2

  Kompressor August 18, 2009, 02:15
  

   Enthusiast

  whoever repaired your gas tank did not do it correctly IF the light is caused be fuel tank not passing integrity test performed semi randomly by engine ECU . This type of code will self clear if system is actually ok ( like if u left the gas cap off then drove away ) after 4 sucessful gas tank tests.. the system (as required by EPA standards) actually appiles vaccum to the gas tank and then see's if the pressure sensor says its holding vaccum (after shutting the main vent located NEAR THE FILLER NECK inside the right rear fenderwell.... i know its acomplicated answer but i hope u understand it alittle..all this to keep vapors from leaking into atmosphere which is a good thing
  Reply
  Flag This
  Like | 1 person likes this1

• Oil leak into wiring harness from camshaft solenoid switch
  Oil can leak into the engine wiring harness from the camshaft solenoid switch. If the leaky sen...

  Common Problems > Mercedes-Benz C230

• P0170 Fault Code
  I keep getting the P0170 fault code for fuel trim malfunction. The first time this fault appeared it also gave a fault code for the oxygen sensor downstream of the catalytic converter. After repl...

  Q&A > Mercedes-Benz > 2004 Mercedes-Benz C230

• i bought the car 3 months ago
  my car started shaking like i had put bad gas in it. now it has a popping sound when i try to start it and when i put it in gear it stops running.the check engine like is also on. does anybody know...

  Q&A > Mercedes-Benz > 1997 Mercedes-Benz C230

• check engine light
  is there a software upgarde to program the engine control module

  Q&A > Mercedes-Benz > 2004 Mercedes-Benz C230

• transmission control module
  will not shift out of second gear. check engine light stays on

  Q&A > Mercedes-Benz > 1999 Mercedes-Benz C230