» » »

Chrysler Q&A

Ask Your Question

2004 Chrysler Crossfire Question: ECM LOCATION

 

Question

HORNFAN10, Holland, TX, March 25, 2013, 14:09
 Rookie

WHERE IS ECM ON MY 2004 CROSSFIRE

1 Answer
Flag This
  • Answer #1

    Miles Auto Services (884 Answers) , Richmond, VA - (804) 885-4176
    milesauto March 25, 2013, 14:32
    Profile_thumbnail
     Master

    That and other modules located in a box in the front hood near R/F fender.

    Flag This
  • Reply

    HORNFAN10, March 25, 2013, 14:40
     Rookie

    I FOUND A RELAY CONTROL MODULE IS TAHT THE SAME ITEM

    Flag This
  • Reply

    milesauto, March 26, 2013, 04:50
    Profile_thumbnail
     Master

    I think not...let me ask for what reason are you looking for the ECM?

    Flag This
  • Reply

    HORNFAN10, March 26, 2013, 06:21
     Rookie

    have had in a shop for 3 months , computer spitting no code's ,started with the crank sensor (after much research from crossfire forum )replaced it ,ran fine for a week then stalled out again no start .did repair on relay control module after (research from crossfire forum ) repaired still no fire from coils out - got another new crank sensor did the same thing , will spin over will not start , gettting fuel ,and spark up to coil's from coils out no fire, (after much research from crossfire forum),was told has to be ecm engine control module found a company to repair it but have to send to them cant find it to ship to them .local dodge dealerships will no touch say they have not the correct computers to diagnose ---

    Flag This
  • Reply

    milesauto, March 26, 2013, 13:56
    Profile_thumbnail
     Master

    I see why you may be frustrated. Alldata shows a picture of the ECM and other modules that are in the same box with a cover on it in rf area under hood. Some parts stores have Alldata for customers to use. I think its Advance or Autozone that owns Alldata. I would copy and paste that picture for you but Alldata will not let me copy their pics. Also I have the old factory scan tool that Chryser used to up to 2005. Its a DRB3 and it has Crossfire software diagnostics. Lots of independant shops that are heavy in diagnostics have these scanners and that might be your best bet to get hooked up to a DRB3. Suggest you call around and ask if someone in your area has one.
    \

    Reply
    Flag This