» » »

Chrysler Q&A

Ask Your Question

2003 Chrysler Concorde Question: DTC codes P0700 and P1776

 

Question

lambede, 3.5L V6, Clayton, NC, September 08, 2010, 16:53
 Rookie

IM getting DTC codes P0700 trans contol sys malfunction and P1776 manufacturer contol transmission. The car is a 2003 chysl. Concorde. I was driving along the freeway when the check engine light came on. nothing else happened. Then about 10 minutes later the car started to act like it was in a loser geear and wouldnt upshift. I pulled into a gas station and turned it off and checked trans fluid. ll was good, drove home with no more problems. Next day went to drive to store. Same problem came back. I can read the codes but dont where to find the info on what it is to fix the problem.

1 Answer
Flag This
  • Answer #1

    September 14, 2010, 15:07
     Master

    I recommend you take your vehicle to your Local Dealership as they are best equipped to diagnosis this concern. A reputable transmission shop would be the next best place to start. here is a link to shops in your area: http://repairpal.com/directory?address=27527&car_brand_names=Chrysler

    P0700 is an informational DTC letting you know that a DTC(s) is stores in the Transmission Control Module (TCM). P1776-SOLENOID SWITCH VALVE LATCHED IN LR POSITION.
    POSSIBLE CAUSES :
    RELATED DTC P0841 PRESENT
    TRANSMISSION CONTROL RELAY OUTPUT CIRCUIT OPEN
    L/R PRESSURE SWITCH SENSE CIRCUIT OPEN
    L/R PRESSURE SWITCH SENSE CIRCUIT SHORT TO GROUND
    L/R PRESSURE SWITCH SENSE CIRCUIT SHORT TO VOLTAGE
    INTERNAL TRANSMISSION
    POWERTRAIN CONTROL MODULE
    INTERMITTENT WIRING AND CONNECTORS

    Reply
    Flag This