Drive belt noise due to improperly installed power steering pump pulleyon Jeep Wrangler

2.5L 4 cylinder
If the power steering pump pulley is not installed in the correct position on the pump shaft, the drive belt may make a chirping noise and sound as though it is coming from another component.

RepairPal Verified
Average mileage : (–)
2 Years Affected: 1991, 1992
2 people reported this problem
0 people shared problem details
Related Items:
I have to pump the gas pedal 20-30 times to get it to crank. do i just need to replace the fuel...
Need advice on replacing serpentine belt. I have replaced belts on numerous vehicles but need a...
put new engine in 1998 jeep wrangler 2.5 4 cylder new water pump radiater thermostat belt afte...
I had my check eng light check out a Advance Auto with there computer. It said it was the Oxg s...
a 3inch lift kit was installed into wrangler i purchased but low 4 wd does not want to go in /...

Related Content