One or both windshield washer nozzles may plug or clog. There are revised washer nozzles available which are more resistant to plugging.
Problems for specific Dodge Stratus years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1999 Dodge Stratus problems
There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.
Spark plug tube seals fail, causing the tubes to fill with engine oil and the engine to misfire. As a result, the engine may run poorly and fuel economy can suffer.
When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault codes stored in the powertrain control module (PCM) should not be trusted. Our technicians tell us that under certain conditions a fault code can be stored for the "good" sensor. Care should be taken to properly diagnose this condition.
If a Check Engine Light illuminates indicating leak detection pump (LDP) failure, the cause is often pinched or disconnected vacuum lines to the pump. Vacuum lines should be inspected before replacing the leak detection pump. Contamination (carbon or debris) in the pump can cause failure and any hoses should be cleared before a new pump is installed.
Low oil pressure light started coming on after highway driving. Reving up engine just a little over idle turned light off. Over about a month, progressively got worse to the point where light would come on within 5 minutes of starting the car and reving engine (except to high RPMs, over 3500) would not turn the light off. Originally thought sending unit must be ok as it appeared to work (coming on and off). Did some research and only thing...
Defective speed sensors on the transmission can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors can corrode and/or the connector terminals can spread (poor connection), which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.
If the car will not start, stalls, or hesitates while accelerating, it may be caused by wires in the wiring harness that are broken internally. This is typically found where the wires pass under the distributor.