1995 Dodge Stratus Problems
RepairPal has identified the most common problems with the 1995 Dodge Stratus as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault codes stored in the powertrain control module (PCM) should not be trusted. Our technicians tell us that under certain conditions a fault code can be stored for the "good" sensor. Care should be taken to properly diagnose this condition.
There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.
Spark plug tube seals fail, causing the tubes to fill with engine oil and the engine to misfire. As a result, the engine may run poorly and fuel economy can suffer.
Defective speed sensors on the transmission can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors can corrode and/or the connector terminals can spread (poor connection), which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.
The automatic transmission used in these vehicles have had a high failure rate. Failures can be due to internal component or electrical component failure.
If a Check Engine Light illuminates indicating leak detection pump (LDP) failure, the cause is often pinched or disconnected vacuum lines to the pump. Vacuum lines should be inspected before replacing the leak detection pump. Contamination (carbon or debris) in the pump can cause failure and any hoses should be cleared before a new pump is installed.
There was a recall on some models to replace the brake master cylinder due to potential leaks.
One or both windshield washer nozzles may plug or clog. There are revised washer nozzles available which are more resistant to plugging.
If the car will not start, stalls, or hesitates while accelerating, it may be caused by wires in the wiring harness that are broken internally. This is typically found where the wires pass under the distributor.