1993 Dodge Spirit Problems
RepairPal has identified the most common problems with the 1993 Dodge Spirit as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Vehicles may develop a start and die out condition or a transmission that defaults to second gear. Our technicians tell us that the transmission control module (TCM) may be at fault and require replacement. If the TCM is replaced the pinion factor should be reset and the quick learn procedure performed.
Vehicles equipped with a 4 cylinder engine may develop a no start or stalling condition, most commonly caused by a failed distributor pickup plate.
Automatic transmissions can exhibit a variety of shifting and noise concerns due to failure of internal parts. Our technicians tell us that a complete inspection of all internal parts should be performed if the transmission is disassembled for overhaul. Numerous updated part are available for this transmission.
A noise from the rear suspension may be noted at slow speeds over uneven road surfaces. This can be caused by a cracked or broken rear torsion bar. A damaged torsion bar will require replacement.
A clicking noise may develop from the left front of the vehicle that varies with vehicle speed. Our technicians tell us that the cause may be the output gear bolt and stirrup contacting the rear cover of the transaxle. The repair involves replacing the transaxle rear cover, fluid filter, and any damaged output gear retention components.
Alternator pulley misalignment on 4 cylinder engines may result in belt noise and/or the belt "walking" partially off the pulley. Our technicians tell us that replacement of the AC and alternator mounting bracket, alternator belt, and if necessary, installation of washers to align the alternator pulley may be necessary to correct this issue.
4 cylinder engines may develop a coolant leak from the water pump area. The sealant used on the water pump may degrade over time, newer models have an upgraded rubber gasket. Our technicians tell us that the o-ring where the water pump housing mounts to the engine block may also leak which can appear to be a leaking water pump.
When driving through deep snow the serpentine belt may be forced off the pulleys. If pulley alignment is found to be OK a shield is available to prevent snow from coming in contact with the belt.
4 cylinder engines may develop one or more of the following concerns: Erratic idle, hesitation, and lack of power. Common causes include: Faulty throttle position sensor, brittle or broken wires & corroded or spread terminals in the engine wire harness, cracked or swollen vacuum hoses, and oil contaminated o2 sensors. Our technicians recommend a complete inspection including diagnoses of any stored fault codes if these driveability concerns occur.
4 cylinder engines may develop driveability issues and illuminate the Check Engine Light due to engine vacuum leaks. These vehicles use plastic vacuum lines which can become brittle due to heat and age. Care should be taken when replacing these lines as some may have a restrictor orifice molded inside. If lines are replaced without including the restrictors driveability issues will remain.
4 Cylinder engines may exhibit an erratic idle with the Check Engine Light illuminated. These conditions are most commonly present during cold engine operation in rainy weather. Our technicians tells us that there is an updated idle air control valve available to correct this concern.
A dirty throttle body can cause a low idle speed resulting in a stalling condition. Our technicians recommend cleaning the throttle body at 15k intervals to help minimize this condition.