Problem Reports

Some vehicles may exhibit one or more of the following: Spark knock complaints when the vehicle is under load, various single cylinder misfire, and surge in 4th gear (around 45 mph). Our technicians tell us that rerouting the coil and spark plug wires to minimize induction effects will commonly correct this condition. If wires must cross during the reroute procedure, they must cross at a 90 degree angle.

On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.

Leak detection pump failure can be caused by the internal diaphragm switch sticking, or in some cases, contamination from debris or carbon particles from vapor canister. If black carbon particles are present in the LDP, replace vapor canister in addition to LDP. The purge solenoid should also be checked for debris or carbon contamination and replaced as necessary. All evap system hoses are subject to cracking and splitting causing leaks, Inspect hoses carefully. In cases of contamination from carbon particles or debris, all hoses and tubes must be blown out with compressed air to remove contaminates.

Our technicians tell us that there is a software upgrade for the ABS module to correct inaccurate speedometer readings.

Intermittent cycling of the door locks especially during damp conditions may occur. Our technicians tell us that revised door and liftgate lock cylinder switches are available.