The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops. There is also a revised vacuum check valve available to address this concern.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1997 Dodge Ram Wagon 1500 problems
The blower motor may operate erratically and the blower switch operation has a sticky or mushy feeling, the detents almost non existent. Our technicians tell us that the blower switch should be removed and inspected for overheating. This is common if the blower motor is frequently operated on high speed as the current flow through the switch tends to melt internal the components. Also carefully inspect all of the switch connector terminals for discoloration due to overheating and replace as required. A poor electrical contact at the connector will also cause the switch to overheat.
Leak detection pump failure can be caused by the internal diaphragm switch sticking, or in some cases, contamination from debris or carbon particles from vapor canister. If black carbon particles are present in the LDP, replace vapor canister in addition to LDP. The purge solenoid should also be checked for debris or carbon contamination and replaced as necessary. All evap system hoses are subject to cracking and splitting causing leaks, Inspect hoses carefully. In cases of contamination from carbon particles or debris, all hoses and tubes must be blown out with compressed air to remove contaminates.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
Some vehicles may exhibit a "buzz", whining", or "moaning" like noise from the transmission when reverse gear is selected. The condition is caused by a resonance of the transmission regulator valve system. Our technicians tell us that the repair involves replacing the transmission regulator (aluminum) valve with a steel one.