1995 Dodge Ram Van 1500 Problems
RepairPal has identified the most common problems with the 1995 Dodge Ram Van 1500 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops. There is also a revised vacuum check valve available to address this concern.
An intermittent connection in the crank position sensor wire connector can cause poor engine performance or the engine may crank but not start.
Insufficient fuel pressure may be caused by particulate contaminates or other type of substances by-passing the primary fuel pick-up screen and resulting in fuel pump failure. Our technicians recommended to replace entire fuel pump module assembly as two (2) filters, primary and secondary are included with the assembly.
The engine may exhibit excessively high oil pressure at cold start up. This may lead to distortion of the oil filter case. Inspect the oil filter case for any signs of distortion. If the case is distorted, Connect an oil pressure gauge to the engine and start the engine while observing the readings. If the pressure reads above 80 psi, replace the oil pump.
The blower motor may operate erratically and the blower switch operation has a sticky or mushy feeling, the detents almost non existent. Our technicians tell us that the blower switch should be removed and inspected for overheating. This is common if the blower motor is frequently operated on high speed as the current flow through the switch tends to melt internal the components. Also carefully inspect all of the switch connector terminals for discoloration due to overheating and replace as required. A poor electrical contact at the connector will also cause the switch to overheat.
Leak detection pump failure can be caused by the internal diaphragm switch sticking, or in some cases, contamination from debris or carbon particles from vapor canister. If black carbon particles are present in the LDP, replace vapor canister in addition to LDP. The purge solenoid should also be checked for debris or carbon contamination and replaced as necessary. All evap system hoses are subject to cracking and splitting causing leaks, Inspect hoses carefully. In cases of contamination from carbon particles or debris, all hoses and tubes must be blown out with compressed air to remove contaminates.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
A surging or bucking during acceleration can be caused if the distributor is moved or mis-indexed. This is a result of the cam and crank position sensors being out of synchronization. Wear of the oil pump drive gear can cause similar symptoms because it allows excessive free play in the distributor drive. The distributor drive gear and bushing should be replaced if the rotor tip moves back-and-forth more than 3/16th of an inch when checking drive gear free play.
The door glass may separate from the glass lift channel. Our technicians tell us a front door glass channel kit is available to repair the door glass. The repair involves removing the door glass from the vehicle.