Engine temp went over 240 degrees for about 3 minutes because of low coolant; it didn't appe...
Q&A
Ask Your QuestionAll 2001 Dodge Ram 2500
Question
Will it damage anything for Engine to have overheat for about 3 minutes
Question
heater not blowing hot inside
heater core is getting hot but insidde blowing cool air
Question
i have 2 codes P0122 and P1693. where are the parts located.
can a normal person replace these or does a shop have to?
Question
does ayone answer the qestions that people post on this site.anywy i need some
help with my truck,im in the prossesing of changeing my fuel pump ,ive already dropped the tank a...
Question
no start condition
starts now and then but most of the time it doesn't the only way to get started is to open f...
Question
Cannot open rear quad cab doors with either inner or outer latches.
I need access the acuator rods to unlatch the doors. The doors try to unlatch but it seems that t...
Question
what type of gear oil do I use for the rear end.
its a 2001 Dodge 2500 cumming 24 valve turbo diesel 4X4,3/4 ton
Question
when driving the truck acts like it stays in first
but when i let off the gas pedal it shifts what is it
Question
Misfires on a Mopar performance long block crate motor/2001 Ram 1500 offroad.
The engine continues to have multiple misfires ever since It was installed in 2005. I'm runn...
Question
After engine warms up oil pressure drops to 0 at idle.
It goes back up to about 28 lbs when rpm reaches 1000 or more.
Question
I don't see an estimate to replace the u-joints for my Ram pickup. Where is it?
My truck is vibrating on acceleration and I would like to get an estimate for replacing the u-joints
Question
High beams won't turn on
The high beams won't turn on. Replaced the bulbs, still don't work. The high beam indic...
Question
My windshield wiper's do not work with delay or wash funtions.
Multi-function switch was replaced. What else could be broke?
Question
How do i find out what is wrong with truck. Wont run, pcode 1693..Wont scan
I know P code 1693 is a companion code... I used a snap on scanner and it said no communication. ...
Question
My automatic trans. is constantly shifting up and down,any ideas?
I have changed fluid & filter.changed vss sensor,even ran w/overdrive off didn't help. s...
This week's top 10
| 1 globalhelper | 6 FREDDY BLUE |
| 2 pushrod | 7 gearhead89 |
| 3 ziptie12 | 8 tdtoolbox |
| 4 ChevyASE | 9 wenyan |
| 5 csubak30 | 10 ebans777 |