2000 Dodge Ram 2500 Problems
RepairPal has identified the most common problems with the 2000 Dodge Ram 2500 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
If the engine is difficult to start or cranks but does not start, it can be caused by a leak in the return side of the fuel system. This type of leak can allow air to enter the injection pump resulting in starting issues. A rubber hose on the back of the injection pump, connecting the pump to the steel hard line, that can be the source of this type of leak.
Replacing a pressure solenoid valve in the transmission valve body may fix an issue where the transmission "hunts" between first and second gears. Our technicians report that customers sometimes describe this complaint as surging or bucking.
On the 3.9L V6 and 5.2L V8, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.
If a Check Engine Light illuminates indicating leak detection pump (LDP) failure, the cause is often pinched or disconnected vacuum lines to the pump. Vacuum lines should be inspected before replacing the leak detection pump. Contamination (carbon or debris) in the pump can cause failure and any hoses should be cleared before a new pump is installed.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.
Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.
When driving over bumps a clicking or squeaking from the rear leaf springs may be fixed by replacing the (leaf) spring tip liners and installing a spring clinch clip (kit available from the dealer).
One the 3.9L V6 and 5.9L V8 the carbon buildup on the top of the piston is common. As the buildup increases with mileage and over time, symptoms may vary from light ticking, to ticking/hammering, to hammering/knocking noises. Fuel injector cleaner often solves the problem.