The abs module connector Is full of water for a little holes in the top of the Connector. I'm need replace module and connector because if fully corroded (pins and connector)
2009 Dodge Ram 1500 Problem Reports
Newest 2009 Dodge Ram 1500 Problem Reports
If the vehicle will not shift into, or out of four wheel drive, and the "Serv 4WD" warning light is illuminated, the front axle disconnect actuator may need replacement and a power module (TIPM) may need a software update.
If a clunking or "loose lumber" noise is coming from the front or rear suspension, there are revised shock absorbers available that can help the concern. This is usually heard at lower speeds and colder temperatures when driving over bumps.
The thermostat may fail to close completely, causing the Check Engine Light to illuminate. This problem will prevent the engine from reaching normal operating temperature; a new thermostat should be installed.
If the engine does not crank (or cranks but won't start), the wireless control module (WCM) may have locked up. This is due to static discharge through the ignition key. A revised model should be installed, but simply disconnecting the negative terminal of the battery for thirty seconds will temporarily reset the module so you can start the car.
On the 3.9L V6, 5.2L V8 and 5.9L V8 the Oil leaks commonly from the valve cover gaskets, intake manifold gaskets (front and rear), timing cover gaskets, distributor O-ring, and the rear main seal area. Using fluorescent engine oil dye can be helpful in determining the source(s) of the oil leak.
For the 4x4 models, a high pitched whistle heard between 30 and 60 miles per hour can be caused if the tie rod adjusting sleeve is oriented in a way that the sleeve slot is facing toward the front of the vehicle. Wrapping tape completely the sleeve will allow you to verify the the sleeve is creating the whistle. Rotating the adjusting sleeve so the slot does not face forward will fix the problem.