If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
2005 Dodge Ram 1500 Problem Reports
RepairPal Verified 2005 Dodge Ram 1500 Problem Reports
The track for the power seat may need to be replaced if the seat rocks when the vehicle accelerates or slows down.
If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.
The thermostat may fail to close completely, causing the Check Engine Light to illuminate. This problem will prevent the engine from reaching normal operating temperature; a new thermostat should be installed.
The throttle body may malfunction in very cold climates causing symptoms at engine start up. A throttle body causing problems will require replacement.
If a Check Engine Light illuminates indicating leak detection pump (LDP) failure, the cause is often pinched or disconnected vacuum lines to the pump. Vacuum lines should be inspected before replacing the leak detection pump. Contamination (carbon or debris) in the pump can cause failure and any hoses should be cleared before a new pump is installed.
Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.
The drip rail door seal may become torn form contact with the lower A-piller. A revised secondary door seal is available to correct this concern. This is not a recall but a technical service bulletin (TSB) which means the failed part will be replaced at the customers expense once the warranty has expired.
On the 3.7L V6 and 4.7L V8 the camshaft position sensor may fail and cause the engine to crank but not start or it can cause intermittent stalling. A failed camshaft sensor will require replacement.
The 3.7L V6 and 4.7L V8 in very cold climates (below freezing temperatures) moisture can collect in the Positive Crankcase Ventilation (PCV) system and freeze. This will cause various drivability problems and there are revised PCV system components to repair this concern.