On the 3.9L V6 and 5.2L V8, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.
Problems for specific Dodge Ram 1500 years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 2002 Dodge Ram 1500 problems
The track for the power seat may need to be replaced if the seat rocks when the vehicle accelerates or slows down.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
If a Check Engine Light illuminates indicating leak detection pump (LDP) failure, the cause is often pinched or disconnected vacuum lines to the pump. Vacuum lines should be inspected before replacing the leak detection pump. Contamination (carbon or debris) in the pump can cause failure and any hoses should be cleared before a new pump is installed.
Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.
On some models a void in the rear window seal may cause a water leak. Water may be present on or under the carpet. The seal will need to be replaced if that is the source.
On the 3.7L V6 and 4.7L V8 the camshaft position sensor may fail and cause the engine to crank but not start or it can cause intermittent stalling. A failed camshaft sensor will require replacement.
One the 3.9L V6 and 5.9L V8 the carbon buildup on the top of the piston is common. As the buildup increases with mileage and over time, symptoms may vary from light ticking, to ticking/hammering, to hammering/knocking noises. Fuel injector cleaner often solves the problem.
A revised return spring is available if the cup holder binds or is slow to open.