at seventy mph the tach will jump and some hesitastion will happen, i've changed fuel pump, ...
Q&A
Ask Your QuestionAll 1997 Dodge Ram 1500
Question
what causes 5.9 dodge ram tach to jump 250/500rpms
Question
Why won't my catalyst monitor and o2 sensor monitor clear?
I replaced the catalytic converter and o2s11 and have driven the truck for almost 300 miles. The ...
Question
Why I'm not getting cold air
I just currently got hot air blowing as I found the plastic gear not engaging to climate control ...
Question
how do i get heater to work
im having trouble getting hot air coming out when switch is on heat,both hoses are hot i already ...
Question
How can I get my temp guage to function?
I have already changed the engine temp sensor and no luck. Anything else?
Question
Why would my oil pressure light stay on even when the engine is warmed?
The oil pressure gauge goes to its normal setting, but the warning light continues to stay on. I ...
Question
My truck hesitates when gas pedal depressed.
When changed the idle sensor and intake manifold pressure sensor but it did not help.
Question
i need the interior fuse panel diagram for the fuse panel in the side of thedash
There isnt an owners manual with the truck. i just need the labeling for the fuses. thanks!
Question
Location of the RAWL ABS Module 1997 Dodge Ram BR1500 Sport
Location of the RAWL ABS Module 1997 Dodge Ram BR1500 Sport. I have been told its located behind ...
Question
Check engine light came on, shows code PO441
I replaced the pvc valve. Someone said it might be the gas cap. The code comes up PO441-Evaperato...
Question
What makes the ASD kick on
I' changed about every sensor, coil, plugs/wires. Truck wont start. timing is on the money. ...
Question
truck will not stay running.
My truck would not start up for me it acted like it wanted to but it would not fire so we replace...
Question
1997 dodge ram 1500 318 ci has popping or backfires when excellerating
have installed new pvc valve, plugs, wires, cap and rotor. fuel pump is approx. 2 years old. have...
Question
I need to know how to remove rear axles to remove the chunck to replace all the
bearings as they are roaring.
Question
What needs to be adjusted in the shifting linkage
The Shifter does not register properly. Wont always start in park but will in neutral. If you cut...
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 FREDDY BLUE |
| 3 ziptie12 | 8 gearhead89 |
| 4 ChevyASE | 9 ebans777 |
| 5 wenyan | 10 tdtoolbox |