2002 Dodge Durango Problems

RepairPal has identified the most common problems with the 2002 Dodge Durango as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
Choose your vehicle
Known Problems

Rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.

On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.

Poor AC performance or no cold air blowing from vents is commonly caused by a refrigerant leak from the AC condenser. Road debris like rocks or pebbles can damage the condenser tubes.

If the engine does not crank (or cranks but won't start), the wireless control module (WCM) may have locked up. This is due to static discharge through the ignition key. A revised model should be installed, but simply disconnecting the negative terminal of the battery for thirty seconds will temporarily reset the module so you can start the car.

A ticking type noise may develop, most noticeable when the engine is cold. This is commonly caused by one or more broken exhaust manifold bolts. Our technicians recommend to replace the broken bolts as needed, also the exhaust manifold gaskets should be replaced at this time.

If the door locks intermittently lock and unlock without pressing the door lock switch, the door and liftgate lock cylinder switches may need replacement. This may occur more often when driving in damp conditions like the rain or through a car wash.

A rough engine idle and/or engine stalling condition may develop, often associated with illumination of the Check Engine Light and an exhaust gas recirculation (ERG) fault code stored. This is commonly caused by a clogged EGR tube. The repair involves cleaning the clogged EGR tube.

On the 4.7L V8 engine, the Camshaft position sensor failure can cause the engine to crank but not start or it can cause intermittent stalling. A new camshaft position sensor will be needed.

If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.

A whining noise heard driving at freeway speeds (more than 55 mph) can be normal noise from the rear axle which is being transmitted through the body. A body/frame damper is available which may help with this concern.

The upper ball joints may fail due to moisture damage. Our technicians tell us 2000-2001 models were recalled for this issue. For more information on this recall, please click here»

Engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

External oil leaks from the valve cover gaskets, intake manifold gaskets (front or rear), and the rear crankshaft seal area are common. The rear main seal is an unlikely source. Normally, leaks in this area are from the bearing cap mating surfaces as well as the sealing surface between the oil pan and bearing cap.